1.Pertama-tama pasang benda kerja

1.



Pertama-tama pasang benda kerja pada cekam. Bisa dengan teknik di cekam atau pun dengan teknik di tumpu dengan center kepala lepas, kemudian setting pahat pada toolpost. 

2. Bubut facing asal rata, setelah itu bor menggunakan centerdrill.

3.

.Bubut lah turning sesuai ukuran


4.

Buatlah alur pada batas ulir. Fungsi ulir adalah

Untuk menetapkan dalamnyaulir 
dan Untuk kebebasan gerak pahat pada akhir langkah.

5.

Pahat Ulir yang sudah diasah dengan sudut yang sesuai

6. Setel posisi Handel-handel Upper lever dan drop lever sesuai dengan roda gigi-roda gigi. Jika tidak sesuai table, gantilah

.7. Jalankan mesin dengan kecepatan terendah dan tekanlah batang penggerak otomatis, kemudian lakukan sayatan awal pada benda kerja.

8.

Lakukanlah pembubutan ulir dengan pemakanan sesuai perhitungan untuk mencapai
Pemakanan secara bertahap

.

9.

Kalo sudah selesai pembubutan ulirnya, kemudian periksalah dengan malulir.

Hasil (Inggris) 1:

1.First of all install the workpiece on dibble. Can with engineering in dibble or technique in the focal center with the head off, then setting the chisel on the toolpost. 2. the original flat facing Lathe, drill using the centerdrill.3.. Lathe is turning the appropriate size4.Make a Groove on the limit screw. The function of the screw isTo set the dalamnyaulir and for the freedom of motion of the chisel on the final step.5.Chisel thread already honed with the appropriate angle 6. set the position of the handle-the handle Upper lever and drop lever in accordance with gears-gears. If the table does not match, change 7. Run the machine with the lowest speed and click Auto drive shaft, then do the initial incision on the workpiece.8.Do pembubutan screw with the consumption calculation according to reachConsumption gradually.9.The reply is over pembubutan ulirnya, then check with malulir.

Hasil (Inggris) 2:

1.  First of all pairs of the workpiece on the dibble. Can be applied here dibble or with engineering centers in the fulcrum of the head off, then setting the chisel on toolpost.  2. Lathe facing flat origin, after the drill using centerdrill. 3. .Bubut was turning to size 4. Make the groove on the thread limit. Screw function is to establish dalamnyaulir  and to freedom of movement of the chisel at the end of the step. 5. Chisel Screw that has been honed by the appropriate angle 6. Adjust the position of the handle Upper Handel-drop lever and lever in accordance with the gear-gear. If it does not fit the table, replace .7. Run the engine at low speed and press the automatic drive shaft, and then perform the initial incision on the workpiece. 8. Do turning the screw with the appropriate calculations to achieve Ingestion Ingestion gradually. 9. If already finished turning ulirnya, then check with malulir.