Slip the correct usage Set Drill Pipe Slip a) Install the slip with your palms facing upwards. B) When the downward movement of the drill pipe has been stopped, slip wrap around the pipe and lower into a rotary bushing. Never kick slip because it can damage dies or impede the pipe. C) Floorman ahrus supervise elevator or the block to make sure not hit the elevator or trapped between the tongs slips. D) Always employ three crew when it set the slip to prevent injury sprain. E) Do not use slip to stop the pipeline when Driller down. Let Driller to stop the pipe with draw works brakes first. The next set slip. Let slip the pipe running to the master bushing to stop it is a habit that is often done which may cause a fall while hooking the pipe. It is also a habit that can result in permanent deformation of pipe are costly. Interesting Drill Pipe Slip a) Raise slip with your palms facing up. B) When lifting slips, take slip upward by moving the pipe. Remove the slip and then place it back slip ajuh of the table. Be sure to use proper lifting techniques (eg, lift with your legs, not with your back). Make sure your legs strong foothold and a good grasp of your hands before starting to lift. C) Never let slip is above the pipe when the pipe Driller lifted out of the pit. Such practices will increase the wear on the slip and can damage the pipeline. This treatment is also an inherent risk of injury if the pipe moves suddenly pull slip out of the turntable. * Caution - If the hole is not in the middle, do not use too much force. Use an upward motion to help pull the drill pipe slip out of the bushing.
Sedang diterjemahkan, harap tunggu..